excavator hydraulic oil level dipstick gauge

July 02, 2021

Excavator's hydraulic oil level can be checked using a dipstick, similar to how you check the oil level in a car engine. Here’s how you can do it:

1.Preparation: Make sure the excavator is parked on a flat and stable surface. The engine should be turned off and allowed to cool down for a while to ensure an accurate reading.

2. Locate the Dipstick: Find the hydraulic oil dipstick. It is usually located near the hydraulic reservoir or oil tank. Sometimes, it might be marked with a label such as "Hydraulic Oil" or "Hydro."

3. Clean the Dipstick: Before checking the oil level, make sure to clean the dipstick thoroughly to avoid any contamination of the measurement.

4. Check the Oil Level: Insert the dipstick fully into its tube and pull it out. The oil level will be indicated on the dipstick. There should be markings that indicate the minimum and maximum levels.

5. Interpret the Reading: Ensure the oil level is between the minimum and maximum marks. If the level is low, it may need to be topped up.

6. Top Up if Necessary: If the oil level is low, add the appropriate type of hydraulic oil through the filler cap. Do not overfill as this can lead to other issues.

7. Recheck: After adding oil, recheck the level to ensure it is within the recommended range.

8. Maintain Regular Checks: Regularly checking the hydraulic oil level is important for maintaining the health and performance of your excavator.

Always refer to your excavator’s manual for specific instructions related to your model, as procedures can vary.

If you need to replace/purchase excavator hydraulic oil level dipstick gauge, please feel free to Send You Inquiry!

Author:

Mr. Ning Xuewen

E-mail:

444820597@qq.com

Phone/WhatsApp:

+86 13808867509